Harken 60.2ST Winche Manuel d'utilisateur

Radial Winch 60.2 STInstallation and Maintenance ManualMRW-02

10Radial Winch 60.2 STInstallation and Maintenance Manual12. Remove the gear n°2 13. Remove the idler and pinion n°1414. Remove roller bearings n°1516

11Radial Winch 60.2 STInstallation and Maintenance ManualIf it is necessary to replace any jaws of the winch, proceed as follows:Once the winch is com

12Radial Winch 60.2 STInstallation and Maintenance ManualExplodedviewwithmaintenanceproducts1.ApplyHarken®greaseonassysocketscrew2.ApplyH

13Radial Winch 60.2 STInstallation and Maintenance ManualAssemblyMake sure that the holes and drainage channels in the base of the winch are not obstr

14Radial Winch 60.2 STInstallation and Maintenance ManualHarken®limitedworldwidewarrantyRefer to the Harken® Limited Worldwide Warranty in the Har

15Radial Winch 60.2 STInstallation and Maintenance ManualExploded viewExplodedview23262127282930242518161781041451115131291222354671920...

16Radial Winch 60.2 STInstallation and Maintenance Manual23262127282930242518161781041451115131291222354671920...

17Radial Winch 60.2 STInstallation and Maintenance Manual*Servicekitavailable;seewinchkitsectiononthewebsitewww.harken.com**Winchproductst

18Radial Winch 60.2 STInstallation and Maintenance ManualRadialWinch60.2STCC=drum in chromed bronze*Servicekitavailable;seewinchkitsectionon

19Radial Winch 60.2 STInstallation and Maintenance ManualRadialWinch60.2STCWC=drum in chromed bronze - W=components RAL 9003*Servicekitavailable;

2Radial Winch 60.2 STInstallation and Maintenance ManualIndexIntroduction 3Technicalcharacteristics 3Weights 3Maximumworkingload 3Outline 3Ins

3Radial Winch 60.2 STInstallation and Maintenance ManualIntroduction - Technical characteristics - OutlineIntroductionThis manual gives technical info

4Radial Winch 60.2 STInstallation and Maintenance ManualInstallationThe winch must be installed on a at area of the deck, reinforced if necessary to

5Radial Winch 60.2 STInstallation and Maintenance ManualTo install the winch you must remove the drum and use Socket Head (SH) bolts.Tools needed:One

6Radial Winch 60.2 STInstallation and Maintenance ManualFollow steps below only to install the winch using hexagonal headed bolts 8. Slide out the cen

7Radial Winch 60.2 STInstallation and Maintenance ManualThedrillingcutouttemplateisavailableontheHarken®website,www.harken.comB. Remove the

8Radial Winch 60.2 STInstallation and Maintenance ManualNOTICEBefore closing the winch, make sure the holes and drainage channels in the base of the w

9Radial Winch 60.2 STInstallation and Maintenance ManualCarry out Installationprocedure (page 5) as shown in the paragraph on winch installation and